Connect the level sensor
On this page, you will find a video on how to connect the level sensor of our double-walled VARIBOX IBCs to your pump system. There are three different level sensors; the empty sensor, the low-level sensor, and the full sensor. The video below will show you how to connect and disconnect the sensors.
Safer
Reusable
Sustainable
Connect the level sensor
There is a plug connection on top of the VARIBOX. A cable with the correct 2-pole plug can be connected here. First, remove the cover from the plug connection and then place the plug on the connection. The plug can only be placed in one way, as can be seen from the slot and the corresponding edge. After insertion, the plug can be secured by tightening the swivel that is around the plug.
The empty sensor
The empty sensor is a sensor in the VARIBOX (option) that knows when the VARIBOX FC is almost empty: when approximately 1-liter liquid is remaining. You can connect your system to the empty sensor that sends a signal when the VARIBOX is almost empty and which can automatically switch off a pump.
The low-level sensor
The low-level sensor is a sensor in the VARIBOX (option) that knows when there are approximately 50 liters of remaining content in the VARIBOX A system can be connected to the low-level sensor, which then emits a signal or switches off the pump.
The full sensor
The full sensor is a sensor in the VARIBOX that knows when the VARIBOX is almost full: approximately 25-liter capacity is left. A system can be connected to the full sensor that emits a signal when the VARIBOX is full or that switches off a pump.
The connection diagram
This diagram gives you guidance on how to set up your installation in connection with the level sensor in a VARIBOX IBC. You can use the sensors to switch off your pump system and/or provide an alarm to act upon.
Couldn’t find your answer in the video connect the level sensor?
We know that the safe and reusable VARIBOX IBCs are being used for many different applications in many different markets. Therefore it could be that your question/answer is not included in the support section. If so, please contact our Customer Service, they are glad to help further.